Komatsu — TORQUE PROPORTIONING DIFFERENTIAL

STRUCTURE AND FUNCTION AXLE TORQUE PROPORTIONING DIFFERENTIAL Function ! Because of the nature of their work, 4-wheel drive loaders have to work in places where the road surface is bad. In such places, if the tires slip, the ability to work as a loader is reduced, and also the life of the tire is reduced. The torque proportioning differential is installed to overcome this prob- lem. ! In structure it resembles the differential of an automobile, but differential pinion gear (4) has an odd number of teeth.

Because of the difference in the resistance from the road surface, the position of meshing of pinion gear (4) and side gear (3) changes, and this changes the traction of the left and right tires. Operation When traveling straight (equal resistance from road surface to left and right tires) ! If the resistance from the road surface to the left and right wheels is the same, the distance between pinion gear (4) and meshing point "a" of left side gear (7) is the same as the distance between pinion gear (4) and meshing point "b" of right side gear (3). ! Therefore the left side traction TL and the right side traction TRANSMISSION are balanced.

When traveling on soft ground (resistance from road surface to left and right tires is different) ! On soft ground, if the tire on one side slips, the side gear of the tire on the side which has least resistance from the road surface tries to rotate forward. Because of this rotation, the meshing of pinion gear (4) and side gear changes. ! If left side gear (7) rotates slightly forward, the distance between the pinion gear and the meshing point "a" of the left side gear becomes longer than the distance between the pinion gear and the meshing port "b" of the right side gear. The position is balanced as follows.

a x TL = b x TRANSMISSION The ratio between the distances to "a" and "b" can change to 1 : 1.38. ! Therefore when the ratio of the distances to "a" and "b" is less than 1 : 1.38 (that is, the difference between the resis- tance from the road surface to the left and right tires is less than 38%), the pinion gear will not rotate freely, so drive force will be given to both side gears, and the tires will not slip. Because of this effect, the tire life can be increased by 20 - 30%, and at the same the operating efficiency is also in- creased. 10-52