Demontage und Montage, Motor komplett Disassembly and reassembly of complete engine Dйmontage et montage moteur complet Despiece y ensamblado conjunto de motor English Franзais Espacol 34. Fit guide bush. 34. Monter la douille de guidage. 34. Montar el manguito de guнa. 35. Lightly oil sealing lip and place new shaft seal onto guide bush. 35. Huiler lйgиrement la lиvre d’йtan- chйitй et placer le joint d’arbre neuf sur la douille de guidage. 35. Untar con un poco de aceite el labio de obturaciyn y colocar el retйn nuevo sobre el manguito de guнa. Note: Sealing lip faces crankshaft. Nota: la lиvre d’йtanchйitй doit ktre orientйe vers le vilebrequin. Nota:
El labio obturante indicarб hacia el cigьecal. 36. Fit shaft seal with press-in device. 36. Monter le joint d’arbre avec le dispositif de montage. 36. Montar el retйn utilizando el dispo- sitivo de introducciyn a presiyn. Note: Observe installation depth. See marking on special tool. Nota: respecter la profondeur de mon- tage. Voir indications figurant sur outil spйcial. Nota: Observar la profundidad de mon- taje. Ver lo indicado al respecto en la herramienta especial. 37. Installation depth possibilities: 37. Possibilitйs de profondeur de montage. 37. Posibles profundidades de montaje: 4 Installation depth 0: standard dimension with perfect shaft seal running surface.
Profondeur de montage 0: cote standard pour surface de roule- ment du joint d’arbre en parfait йtat. Profundidad de montaje 0: medida normal si la superficie de roce del retйn estб en buenas condiciones. Installation depth 1: offset installation with existing run-in groove on shaft seal run- ning surface. Profondeur de montage 1: montage dйcalй avec rainure de guidage sur surface de roulement de joint d’arbre. Profundidad de montaje 1: posiciyn desplazada si existe una huella de roce en la superficie de roce del retйn. © 2002 / 0297 9763 4.00.22