Demontage und Montage, Motor komplett Disassembly and reassembly of complete engine Dйmontage et montage moteur complet Despiece y ensamblado conjunto de motor English Franзais Espacol 77. Place new shaft seal onto press-in device. 77. Placer le joint d’arbre neuf sur le dispositif de montage. 77. Colocar el retйn nuevo sobre el dispositivo de introducciyn a presiyn. Note: Sealing lip faces crankshaft. Nota: la lиvre d’йtanchйitй doit ktre dirigйe vers le vilebrequin. Nota: El labio de obturaciyn indica hacia el cigьecal. 78. Fit shaft seal using press-in device. 78. Monter le joint d’arbre avec le dispositif de montage. 78. Montar el retйn mediante el dispositivo de introducciyn a presiyn.
Note: Observe installation depth. See marking on special tool. Nota: respecter la profondeur de montage. Voir indications figurant sur outil spйcial. Nota: Observar la profundidad de mon- taje. Ver lo indicado al respecto en la herramienta especial. 79. Installation depth possibilities: 79. Possibilitйs de profondeur de montage. 79. Posibles profundidades de montaje: Installation depth 0: standard dimension with perfect shaft seal running surface. Profondeur de montage 0: cote standard pour surface de roule- ment de joint d’arbre en parfait йtat. Profundidad de montaje 0: medida normal si la superficie de roce del retйn estб en buenas condiciones. Installation depth 1:
offset installation with existing run-in groove on shaft seal run- ning surface. Profondeur de montage 1: montage dйcalй avec rainure de guidage sur surface de roulement de joint d’arbre. Profundidad de montaje 1: posiciyn desplazada si existe una huella de roce en la superficie de roce del retйn. 80. Fit idler pulley with new O-ring. 80. Monter le galet tendeur avec un joint torique neuf. 80. Montar la polea tensora con un anillo tyrico nuevo. 4 Tightening specification: 21 Nm Consigne de serrage: 21 Nm Prescripciyn de apriete: 21 Nm 4.00.33 © 2002 / 0297 9763