daewoo G20E-3, G25E-3, G30E-3 — Daewoo G20E-3, G25E-3, G30E-3 — спецификация (EN)

Removal and Installation Removal steps 1. Bolt 2. Starter 6EN0867 Inspection Pinion Gap Adjustment (1) Disconnect the field coil wire from terminal M of the magnetic switch. (2) Connect a 12 V battery between terminal S and starter motor body (positive terminal to terminal S). Caution: This test must be performed quickly (in less than 10 seconds) to prevent the coil from burning out. S Stopper Pinion gap (3) Set switch to “ON”, and pinion will move out. (4) Check pinion to stopper clearance (pinion gap) with a thickness gauge. Pinion gap:

0.5 to 2.0 mm (0.0197 to 0.0787 in.) Pinion 6EN1918 (5) If the pinion gap is out of specification, adjust by adding or removing gaskets between magnetic switch and front bracket. G424 Service Manual Starting System 39