daewoo G20E-3, G25E-3, G30E-3 — Daewoo G20E-3, G25E-3, G30E-3 — спецификация (EN)

Pull-in Test of Magnetic Switch S M (1) Disconnect field coil wire from terminal M of magnetic switch. (2) Connect a 12V battery between terminal S and terminal M. Caution: This test must be performed quickly (in less than 10 seconds) to prevent coil from burning. Disconnect connector (3) If pinion moves out, then pull-in coil is good. If it doesn’t. replace magnetic switch. 6EN0871 Hold-in Test of Magnetic Switch (1) Disconnect field coil wire from terminal M of magnetic switch. (2) Connect a 12V battery between terminal S and body. S Caution: This test must be performed quickly (in less than 10 seconds) to prevent coil from burning.

Disconnect connector (3) Manually pull out the pinion as far as the pinion stopper position. (4) If pinion remains out, everything is in order. If pinion moves in, hold-in circuit is open. Replace magnetic switch. 6EN0872 Return Test of Magnetic Switch M (1) Disconnect field coil wire from terminal M of magnetic switch. (2) Connect a 12V battery between terminal S and body. Caution: This test must be performed quickly (in less than 10 seconds) to prevent coil from burning. Disconnect connector (3) Pull pinion out and release. If pinion quickly returns to its original position, everything is in order. If it doesn’t, replace magnetic switch. 6EN0873 Caution:

Be careful not to get your fingers caught when pulling out the pinion. G424 Service Manual Starting System 40