Maguetic switch “S” teminal Disassembly Service Points A Magnetic switch removal “B” terminal Disconnect the field coil wire from terminal M of the magnetic switch “M” terminal Fieldcoid wire Caution: When removing the armature, take care not to lose the ball (Which is used as a bearing) in the armature end. B Armature/ball removal 6EN0610 Socket C Snap ring/stop ring removal (1) Press stop ring off snap ring with a suitable socket. Stop ring Pinion gear Armature Overrunning clutch 6EN0611 Snap ring Snap ring pliersa (2) Remove snap ring with snap ring pliers and then remove stop ring and overrunning clutch.
Pinion gear Overrunning clutch Armature 6EN0612 Cleaning of Starter Motor Parts Do not immerse the parts in cleaning solvent. Immersion of the yoke, field coil assembly and/or armature will damage to insulation. Do not immerse the drive unit cleaning solvent. Overrunning clutch is pre-lubricated at the factory and solvent will wash lubricant form clutch. The drive may be cleaned with a brush moistened with cleaning solvent and wiped dry with a cloth. G424 Service Manual Starting System 43