I nspection 1. Commutator (1) Place the armature on a pair of V-blocks and check the runout using a dial gauge. Standard value: 0.5 mm (0.020 in.) Limit: 0.1 mm (0.004 in.) 1EN0298 (2) Check the outer diameter of the commutator. Standard value: 29.4 mm (1.16 in.) Limited: 28.8 mm (1.13 in.) 1EN0302 Under cut (3) Check depth of the undercuts between the segments. Standard value: 0.5 mm (0.020 in.) Limited: 0.2 mm (0.008 in.) Segment Mica 1EN0296 2. Overrunning Clutch Check (1) While holing clutch housing, rotate the pinion. Drive pinion should rotate smoothly in one direction, but should not rotate in opposite direction.
If clutch does not function properly, replace overrunning clutch assembly. (2) Inspect pinion for wear or burrs. If pinion is worn or burred, replace overrunning clutch assembly. If pinion is damaged, also inspect ring gear for wear or burrs. Free 3. Front And Rear Bracket Bushing Check Inspect bushing for wear or burrs. If bushing is worn or burred, replace front bracket assembly or rear bracket assembly. G424 Service Manual Starting System 44