5. Enrichment system Enrichment and Accelerator-Pump systems The enrichment system provides additional fuel feed to the main metering system during high- speed large-torque operation. This system use the membrane (diaphragm) which is actuated by the intake manifold vacuum and membrane spring to open or close the fuel feed line. During partial-throttle operation, a large manifold vacuum is applied to the vacuum chamber through the vacuum line and acts on the membrane to close the valve against the membrane spring force. When the throttle is opened wide, manifold vacuum decreases. This allows the membrane spring to open the valve.
Now, more fuel from the float chamber is metered by the enrichment jet and can flow through the valve into the primary main line leading to the main metering system. membrane is pushed by the pump lever linked to the throttle valve and forces fuel to flow under pressure. When the engine is decelerated, the membrane is pushed back by the spring and the pump chamber is refilled with fuel. Pump delivery decreases with engine speed from which acceleration is starred. It does not deliver fuel at all when the angle of throttle valve from the idling position exceeds the preset angle. 7.
Stating system The starting system consists of the choke valve, lever assembly, choke connecting rod, and choke operating lever. This system is provided for feeding a very rich air-fuel mixture to the engine when the engine is started (until the engine warms up) or when a temporary increase of output is needed during engine operation. When the engine is cold, some throttle opening must be maintained so that the engine idles faster then it would when warm. This is done with “fast idle.” With the fast idle, the choke valve is closed while the throttle valve is held at a partially opened position most suitable to warming-up run. 6.
Accelerator-pump system Rapid opening of the throttle for acceleration allows a sudden inrush of air. Thus there is a sudden demand for additional fuel. To provide this extra fuel, the accelerator-pump system can feed fuel immediately under pressure. Fuel from the inlet check valve is sent to the pump nozzle through the outlet check valve by reciprocating movement of the membrane. The fuel is then injected into the main bore. When the engine is accelerated quickly, the G424 Service Manual Gasoline Fuel System 63