daewoo G20E-3, G25E-3, G30E-3 — Daewoo G20E-3, G25E-3, G30E-3 — спецификация (EN)

Choke lever Choke shaft I nspection and Adjustment After Reassembly 1. Fast Idle Opening (1) Move the choke lever to place the choke valve in fully closed position. 6EN0859 Primary throttle valve (2) Measure the clearance “A” (primary throttle valve to throttle bore). NOTE: Refer to the table in SERVICE SPECIFICATIONS for the clearance. Clearance “A” (drill bit diameter) 6EN1889 (3) If the clearance “A” is out of specifications, adjust to the standard value by the fast idle adjusting screw. Fastidle adjusting screw 6E0860 2.

Choke valve Operation (1) With the choke valve lever set to its full position, move the choke valve with a finger to make sure that the choke valve shaft has not an excessive play and the valve moves smoothly without sticking. (2) If the choke valve can not be moved smoothly, clean the choke valve and the area around it. (3) If the play of the choke valve shaft is excessive, replace the float chamber cover. G424 Service Manual Gasoline Fuel System 71 Screw direction of rotation Clearance Remarks Clockwise Increases Fast idle speed increases Counterclockwise Decreases Fast idle speed decreases