daewoo G20E-3, G25E-3, G30E-3 — Daewoo G20E-3, G25E-3, G30E-3 — спецификация (EN)

Carburetor valve (2) measures the air flow that goes into the engine, respective to the demands of the engine and throttle valve (10) position. The air pressure drop of 1.3 to 2.7 kPa (0.2 to 0.4 psi) is controlled by metering spring (4) which permits the force necessary to pull in the fuel into the air flow. LP gas metering valve (6) is connected to the air valve and lets in the correct amount of fuel from the LP converter to mix with the air at any opening of the air valve. The carburetor is equipped with two limited mixture adjustments. Idle air screw (1) directs atmosphere (air) around the opening of air valve (2).

As the idle air screw is adjusted open, the air valve loses a little more and causes the gas metering valve to close. The result will be less fuel in the mixture at idle. The second adjustment is power mixture adjustment (7). It controls the fuel mixture when gas metering valve (6) is fully in the up position. This adjustment is done only when the engine is at a load condition. A CO meter or exhaust analyzer is used for the power mixture adjustment. This adjustment has no effect at idle or in the light load range. 5 4 3 2 1 6 7 8 9 10 IDES070S LP Fuel Carburetor Schematic (1) Idle air screw. (2) Air valve. (3) Diaphragm. (4) Metering spring. (5) Passage. (6) LP gas metering valve.

(7) Power mixture adjustment. (8) Carburetor. (9) Piston. (10) Throttle valve. Lift trucks with LP (Liquid Petroleum) fuel system use an air valve type of carburetor (8). The operation of the carburetor controls the fuel mixture flow into the engine with the movement of throttle valve (10) and mixes the air flow with the LP fuel flow. The air flow is measured by the operation of air valve (2) in the carburetor bowl. The stronger the air flow through the carburetor, the higher the air valve moves up. LP gas metering valve (6) is connected directly to air valve (2). As the air valve moves up, LP gas metering valve (6) also moves up.

LP gas metering valve (6) is shaped to let in the correct amount of LP gas at any height related to air valve (2) upper movement. The air valve activates a pressure drop which gives a very high metering force (measured suction) to the fuel that flows in the carburetor at low engine speeds and it permits easy starting. At full engine speeds, the air valve is at the top of its upper movement. The valve then becomes an inverted (up side down) venturi and will let a large amount of air pass through. When starting the engine, the intake stroke of piston (9) causes lower than atmosphere pressure (vacuum) in the carburetor.

The vacuum is felt through passage (5) in air valve (2) and in the upper side of diaphragm (3). As a result, the atmospheric pressure flows in the carburetor and pushes up on the diaphragm. Diaphragm (3) is lifted against the down pressure of metering spring (4). The vacuum that is felt on diaphragm (3) is variable according to engine speed and the position of throttle valve (10) opening. Air G424 Service Manual LPG Fuel System 76