daewoo G20E-3, G25E-3, G30E-3 — Daewoo G20E-3, G25E-3, G30E-3 — спецификация (EN)

LP Carburetor (Variable Venturi) ports (9) in the air valve (3). A pressure / force imbalance begins to build across the air valve diaphragm (5) between the air valve vacuum chamber (8) and atmospheric pressure below the diaphragm (10). The variable venturi air/fuel mixer is mounted in the intake air stream between the air cleaner and the intake manifold. The design of the main section incorporates a cylindrical bore through the center (1) and a gas discharge jet (2). Incorporated into the inlet of the mixer bore is the air valve (3), tapered gas metering valve (4), air valve diaphragm (5) and calibrated air valve metering spring (6).

The gas valve (4) is permanently attached to the air valve (3) with a face seal mounted in between the two parts (the air- gas valve assembly is mounted in the center of and supported by the diaphragm). When the engine is not running this face seal creates a gas tight seal against the gas discharge jet (2), with the downward force of the calibrated air valve spring (6). A throttle valve (7) is incorporated into the carburetor assembly.

As the negative pressure in the air valve vacuum chamber (8) reaches setting value of water column the air valve (3) begins to lift against the pressure of the calibrated air valve metering spring (6) .The amount of negative pressure generated is a direct result of throttle position and the amount of air flowing through the mixer into the engine. As the air valve (3) rises it lifts the tapered gas metering valve (4) off its seat and exposes the gas discharge jet (2) to the negative pressure signal generated within the mixer bore. This allows the negative pressure signal to travel to the secondary vacuum chamber of the pressure regulator and operate the regulator.

I he profile of the tapered gas valve (4), in conjunction with the regulator spring, meters out the desired A/F ratio. 3 9 6 8 A/F mixture at idle is adjusted with a tapered idle screw (not shown) which is capped at production and cannot be adjusted. A/F ratio at maximum load is limited by the fixed main mixture jet (11), which is sized for the application. In addition the assembly includes two manifold sensors, one for switching the ECU control (13) depending on engine load, and the other for operating a lock-off solenoid (14). In addition the unit is fitted with a precisely controlled vacuum port (12) to allow control of ignition timing by vacuum load control. 5 10 4 2 1 12 11 7 14 13 1.

Mixer bore 2. Gas discharge jet 3. Air valve 4. Gas valve 5. Air valve diaphragm 6. Air valve spring 7. Throttle valve 8. Air valve vacuum chamber 9. Vacuum transfer ports 10. Atmospheric pressure 11. Fixed main mixture jet 12. Vacuum port 13. Vacuum switch (MAP) 14. Vacuum switch As the engine is started it begins to draw in air. Since the air valve (3) is covering the inlet to the mixer bore a negative pressure begins to build. This negative pressure signal is communicated to the air valve vacuum chamber (8) through four vacuum transfer G424 Service Manual LPG Fuel System(Low Emission Version) 89