daewoo G20E-3, G25E-3, G30E-3 — Daewoo G20E-3, G25E-3, G30E-3 — спецификация (EN)

Tests or Adjustments Adhere to the following warnings when performing any tests or adjustments while the engine is running. WARNING Work carefully around an engine that is running. Engine parts that are hot, or parts that are moving, can cause personal injury. 9. When reassembling mixer, locate the notch on air/gas valve diaphragm to point to fuel inlet. WARNING 10. Open the fule storage container liquid outlet valve solwly. Exhaust fumes contain carbon monoxide (CO) which can cause personal injury or death. Start and operate the engine in a well ventilated area only. In an enclosed area, vent the exhaust to the outside. 11. Check for leaks. 12. start engine and verify normal operation.

Check engine idle speed Check engine low idle speed. If it does not meet specification, adjust idle speed adjustment screw. LP Carburetor-Check, Clean Check and Clean LP Carburetor. Low idle speed specification : 700+/-25 rpm The LP Carburetor requires periodic inspection, and cleaning. Inspection and cleaning are as follows : 1. Start engine. 2. Close the liquid outlet valve in the fuel storage container. 3. Run engine out of fuel. 1 2 3 4 NOTICE The idle air/fuel mixture is factory set, therefore, no further adjusstments are required. The part throttle air/fuel mixture is factory set, therefore, no further adjusstments are required.

The full power air/fuel mixture is factory set, therefore no, further adjustments are required, either. 4. Remove mixer lid (4). 5. Remove air valve (2) and spring (3). Inspect and lubricate throttle cable linkage every 500 service hours or 3 months. 6. Clean air valve with warm soapy water. 7. Clean mixer throat with approved carburetor cleaner. 8. Inspect air valve and mixer throat for wear, repair/replace as required. G424 Service Manual LPG Fuel System(Low Emission Version) 96