. OPERATION OPERATION CHANGE OF MACHINE FROM TRANSPORTATION POSTURE TO OPERATION POSTURE the connector at the center of the 3 - 69 CHANGE OF MACHINE FROM OPERATION POSTURE TO TRANSPORTATION POSTURE 1. When transporting the feed er, insert securing pins into the two holes on the right and left sid es at the fron t, and tighten the stopper bolts an d washers. right and left corners of the hopper. [Wedge AGL height: 3.4 m (11 ft 2 in)] ng a pipe and hammer. (A guide for the pipe is in place) ght side of the machine. 2. Remove the wedges at the right and left corners of the hopper. [Wedge AGL height: 3.4 m Working mode: (1)Use a ladder or scaffold.
(2)Drive out the wedges usi ng a pipe and hammer. (A guide for the pipe 3. Remove a handrail on the ri 4. Take out a hopper control s witch box from the tool box and insert it into a connector at the c enter of the h opper underside. [Cable length: 4 m (13 ft 1 in)] t low idling. to extend the cylinder rod and set ing lever to the release position e lever with a pin. (2) to retract the cylinder rod and ng lever to the fixation position ine) to secure the lever with a pin. or the opposite side, using left UP witch (4). ox from the connector and store it in the tool box. 5. Start the engine and run it a 6. Depress right UP switch (1) the 7. (toward the crusher) to fix th 8.
Depress right DOWN switch to f old the side hopper. 9. Pu ll the right hopper locki (toward the rear of the mach 10. Carry out the same works f switch (3) and left DOWN s 11. Stop the engine. 12. Detach the hopper control b ox from the connector and store it in the too 1. Confirm that both right and l eft hopper locking levers are pulled to the fi 2. Take out a hopper control machine underside. [Cable 3. Start the engine and run it a 4. Depress right UP switch (1) raising the side hopper, an upper pin is on the seat. 5. Depress right DOWN switch let the tip of the upper pin c 6. Carry out the same works f switch (3) and left DOWN s 7. Stop the engine. 8.
Insert a wedge at the right [AGL height of wedges: 3.4 Working mode (1) Use a ladder or scaffold. (2) Climb on the feeder to c 9. Remove the feeder in-trans 10. Detach the hopper control b in t