eng — OPENING-CLOSING TYPE HOPPER

. OPERATION OPERATION PROCEDURES FOR DISASSEMBLING OPENING-CLOSING TYPE HOPPER WARNING disassemble the hopper, carry out the disassembly and subsequent PROCEDURES FOR REASSEMBLING OPENING-CLOSING TYPE HOPPER Reassemble the hopper in the reverse order of disassembly. 3 - 70 If it becomes necessary to climb on th e feeder to install a hook, when removing the we dges, be su re to stop the e ngine, attac h a safety belt to the worker and then start the work. I n c ase transport regulations nece reassembly works in the following DETACHING SIDE HOPPER nd left corners of the hopper. [AGL height of wedge: 3.4 m (11 ft 2 in)] Remove the wedges at the right a nd left corners of the hopper.

[AGL height of wedge: 3.4 m (11 ft 2 in)] Working mode (1) Use a ladder or scaffold. (1) (2) Drive out the wedges with a ha mmer and pipe, standing on the ground. ( A guide fo r the pipe is in place on t he hopper) e hopper opening-closing cylinder. [AGL of cylinder head: 3.4 m (11 ft 2 in)] out the work. Pull out the cylinder head pin of th e hopper opening-closing cylinder. [AGL o f cylinder head: 3.4 m ( 11 ft 2 Working mode (1) Use a ladder or scaffold. (1) (2) Climb on the feeder and carry Insert two eyebolts (M20 x 2) into the inside of the side hopper and set a liftin g hook to the eyebolts. (Side hopper weight:

754 kg (1663 lb)/piece) ion of the hopper support (at two points on one side) to completely detach the l box) Pull (Store the removed pins in the too DETACHING REAR HOPPER 1. 2. 3. 1. Insert two eyebolts (M20 x 2) in to the inside of the rear hopper and set a lif ting hook t o the eyebolts . [AGL height of loop: 3.2 m (10 ft 6 in)] 4 bolts). remove them only after keeping a record of the location and the number) opper weight: 344 kg (759 lb)] 2. Remove securing bolts (M24 x (In case shim plates are used, remove them only after keeping a record of the loca tion and t he n umber 3. Lift up the rear hopper.

[Rear h DETACHING FRONT AND REAR H OPPER SUPPORTS the hopper locking lever that is fitted inside the hopper support. locking plate to the hopper frame, using a rubber band) 1. 2. 3. 4. 1. Detach a clamp for the wire of the hopper locking lever that is fitted insid e the hopp (Fasten the detached wire and locking plate to the hopper frame, using a rubber b 2. Pass a lifting wire rope throug h the pin hole (φ71.5) at the lower position of the hop per support. [ AGL height of pin hole: Front 3.1 m (10 ft 2 in ) and rear 2.9 m (9 ft 6 in)] 4 bolts). remove them only after keeping a record of the location and the number) 111 kg (245 lb) /piece and rear 99 kg (218 lb) /piece] 3.

Remove securing bolts (M24 x (In case shim plates are used, remove them only after keeping a record of the loca tion and t he n umber 4. Lift up the hopper supports. [Hopper support weight: Front 111 kg (245 lb) /piece and rear 99 kg (218 lb) /piece LOCKING FEEDER 1. 1. Pass the feeder in-transport se curing pins through the holes at the front r ight and le ft spring seat s, and tighten the stopper bolts and washers .