eng — IF BATTERY IS DISCHARGED

. OPERATION TROUBLESHOOTING IF BATTERY IS DISCHARGED WARNING It is dangerous to charge a battery when mounted on a machine. Make 3 - 112 sure th at it is dismounted before charg ing. y, stop the engine and turn the When c hecking or handling the batter starting switch key to the OFF position. The bat tery generates hydrogen gas, s o there is a hazard of explosion. Do not bring lighted cigarettes near the battery, or do anything that will cause s parks. Battery electrolyte is dilute sulfuric aci d, and it will attack your clothes and ski n. If it gets on your clothes or on your skin, immediately wash it off with a large amount of water.

If it ge ts in your eyes, wash it out with fresh w ater and consult a doctor. andling batteries, always wear protective goggles and rubber When h gloves. When r emoving the battery, first discon nect the cable from the ground (norma lly the negative (-) terminal). Wh en installing, install the positive (+) term inal first. If a tool touches the positive terminal a nd the chassis, there is danger that it w ill cause a spark, so be extreme ly careful. If the te rminals are loose, there is dange r that the defective contact may generat e sparks that will cause an expl osion.

When r emoving or installing the termin als, check which is the positive (+) term inal and which is the negative ( -) terminal. REMOVE AND INSTALL BATTER Y ve the ground cable (normally connected to the negative (-) terminal). Before removing the battery, remo ve the ground cable (normally connected to the neg If any t ool touches between the po sitive terminal and the chassis, there is a hazard of sparks being generated. When installing the battery, connec t the ground cable last. it with battery fitting. ry terminal: 9.8 to 14.7 N·m (1 to 1.5 kgf·m, 7.2 to 10.8 lbft) When replacing the battery, secure Tighte ning torque:Tightening batte ry terminal:

9.8 to 14.7 N·m (1 to 1.5 kgf·m, 7.2 to 1