eng — IF BATTERY IS DISCHARGED

. OPERATION TROUBLESHOOTING PRECAUTIONS WHEN CONNECTING AND DISCONNECTING BOOSTER CABLE WARNING 3 - 113 PRECAUTIONS FOR CH ARGING BATTERY roperly, it may explode. Accordingly, ATTERY IS DISCHARGED (PAGE manual attached to the charger, and ger to match the voltage of the battery ct voltage is not selected, the charger an explosion. charger clip of the charger to the battery, then connect the negative (-) er to the negative (-) terminal of the clips securely. If t he battery is charged imp charge it according to "IF B ATTERY IS DISCHARGED (P AGE 3-112)" and the instruction manual attached to the charger, and observe the following items.

Set the voltage of the char ger to match the voltage of the b attery to be charged. If the corre ct voltage is not selected, the ch arger may overheat and cause an explosion. charger clip of the charger to the Connect the positive (+) positive (+) terminal of the battery, then connect the negati ve (-) charger clip of the charg battery. Be sure to fix the Set the charging current t o 1/10 of the value of the rated b attery capacity; when carrying out rapid charging , set it to less than the rated ba ttery capacity. If the charger current is too high, the electrolyte will leak or dry up , and t his may cause the battery to catch fire and explode.

If the battery electrolyte i s frozen, do not charge the battery or start the engine with a different power source. s will ignite the battery electrolyte and cause the battery to explode. There is a danger that thi s will ignite the battery electrolyt e and cause the battery to exp Do not use or charge the b attery if the battery electrolyte le vel is below the LOWER LEVE L line. This ma y cause an explosion. Check the b attery electrolyte level periodica lly an d add distilled water to br ing the electrolyte l evel to the UPPER LEVEL line .

STARTING ENGINE WIT H BOOSTER CABLE When starting the engine wi th a booster cable, do as follows When connecting the cables, never contact the positive (+) and ne gative (-) terminals. When starting the engine w glasses. ith a booster cable, always wear safety Be careful not to let the norm al machine and problem machine c ontact each other. This prevents spa rks from generating near the battery which could ignite the hydrogen ga s given off by the battery. If hydroge n gas explodes, it could cause seri ous injury. Make sure you do not make a mistake in connecting the booster c ables.

Make the final connection to the engine block, be aware that s parks might be generated when thi s is done, so connect to a place as far as possible from the battery. (H owever, avoid connecting the cable to the work equipment, as conducti on is poor.) e cables from the machine that has been Use care when removing th started. To avoid hydrogen explosion, do not allow the cable e nds to contact each other or the ma chine.