eng — IF BATTERY IS DISCHARGED

. OPERATION TROUBLESHOOTING STARTING ENGINE CAUTION 3 - 114 NOTICE and clip should be suitable for the battry size. The size of the booster cable and clip should be suitable for th e battr y size The battry of the normal mac hine must be the same capacity a s that of the engine to be starte Check the cables and clips f or damage or corrosion. d clips are firmly connected. vers of both machine are in the LOCK position. e NEUTRAL position. Make sure that the cables an Check that the safety lock le vers of both machine are in the L OCK po sition Check that each lever is in th CONNECTING THE BOOSTE R CABLE f the normal machine and proble .

Keep the starting switch o machine in the OFF position Connect the booster cable a s follows, in the order of the n umber marked in the diagram. 1. Connect one clip of b terminal of the problem 2. Connect the other clip o terminal of the normal m 3. Connect one clip of b terminal of the normal m 4. Connect the other clip of of the problem machine. ooster cable (A) to the positive (+ machine. f booster cable (A) to the positive (+ achine. ooster cable (B) to the negative ( achine. 1. 2. 3. 4. 1. terminal of the problem 2. Connect the other clip o terminal of the normal m 3. Connect one clip of b terminal of the normal m 4.

Connect the other clip of booster cable (B) to the engin e bloc of the problem machine. Check that the travel lever safet y lock is set at the LOCK position, irrespective of whether the mac hine is in a norma l cond ition or broken down. 1. Make sure the clips are firmly connected to the batter y terminals. . 2. Start engine of the norm al machine and run it at high i dling s peed 3. Turn the starting switch of the problem machine to the STAR T position and start t If the engine doesn't sta rt at first, try again after 2 minutes or so. DISCONNECTING THE BOOS TER CABLE d, disconnect booster cables in th were connected. After the engine has starte reverse order in which they 1. 2. 3. 4. 1.

Remove one clip of boos ter cable (B) from the engine block o the problem machine. 2. Remove the other clip of booster cable (B) from the negative ( terminal of the normal m achine. oster cable (A) from the positive (+ achine. 3. Remove one clip of bo terminal of the normal m 4. Remove the other clip of booster cable (A) from the positive (+ terminal of the problem machine.