. MAINTENANCE GUIDE TO MAINTENANCE CHECK SERVICE METER: Check the service meter reading every day to see if the time has come for any necessary maintenance to be performed. KOMATSU GENUINE LUBRICANTS: For lubrication of the machine, use the Komatsu genuine lubricants. Moreover use oil of the specified viscosity according to the ambient temperature. FUEL STRAINER: 4 - 2 GUIDE TO MAINTE Do not perform any inspectio n and maintenance operation that is no t found in Stop the machine on flat hard ground when performing inspections a nd maintenance KOMATSU GENUINE REPLAC EMENT PARTS: Use Komatsu genuine parts s pecified in the Parts Book as replacem ent parts CLEAN OIL AND GREASE:
Use clean oil and grease. Als o, keep the containers of the oil and gre ase clea n. Keep foreig n materials a way from oil and grease. CHECKING FOREIGN MATERI ALS IN DRAINED OIL: After oil is changed or filters ar e replaced, check the old oil and filters fo r metal p articles and for eign material s. If l arge quantity of metal particles or suitable action. foreign materials are found, always report to the person in charge, and carry out harge, carry If an oil filler port is equipped with a strainer, do not remove it, when adding o WELDING INSTRUCTIONS: switch. 0 V continuously. within 1 m (3.3 ft) of the area to be welded.
If grounding cable is connected near tc., the instruments may malfunction. Turn off the engine starting Do not apply more than 20 Connect grounding cable instruments, connectors, e tc., the instruments may malfunction. If a seal or bearing happen s to come between the part being welde d and gro unding point, change the g rounding point to avoid such parts. d the work equipment pins or the hydraulic cylinders as the grounding point. Do not use the area aroun d the work equipment pins or the hydra ulic cylind ers as the gro unding point DO NOT DROP THINGS INSID E MACHINE:
When opening inspection windows or the oil filler port of the tank t o carry o ut inspection, be careful n ot to drop nuts, bolts, or tools inside t If such things are dropped i lead to failure. If you drop he machine. nside the machine, it may cause damag e and/or malfunction of the machine , an d will anything inside the machine, always re move it i mmediately. r inspection. Do not put unnecessary thi ngs in your pockets. Carry only things which ar e necessary fo r inspection. DUSTY WORKSITES: ites, do as follows: ging monitor frequently to see if the air cleaner is clogged. ent at a shorter interval than specified. quently to avoid clogging. filter frequently.
When working at dusty works Inspect the air cleaner clog ging monitor frequently to see if the air cleaner i Clean the air cleaner elem Clean the radiator core fre Clean and replace the fuel Clean electrical componen ts, especially the starting motor and alt ernator, t o avoid accumulation of du