eng — GUIDES TO MAINTENANCE

. MAINTENANCE GUIDE TO MAINTENANCE into the oil. AVOID MIXING OILS: LOCKING THE INSPECTION COVER: injury to the worker. mounting 4 - 3 When inspecting or changing the o il, move the machine to a place that is free o f dus t to prevent dirt from getting If a different brand or grade of oil has to be added, drain the old oil and replace all th e oil with the new brand o r grade of oil. Never mix different brand or gr Lock inspection cover securely into maintenanc with inspection cover not locked in positio n, there is a danger that it may be suddenly b lown shu t by the win d and cause HYDRAULIC SYSTEM - AIR BLEEDIN G:

When a hydraulic component is repa ired or replaced, or when a hydraulic piping i s removed, b leeding air from the hydraulic circuit is required. See the section of AIR-BLEEDING FROM HYDRAU LIC CIRCUIT (PAGE 4-8) for the air bleeding. HYDRAULIC HOSE INSTALLATION: where there are O-rings or gasket seals, clean forget to assemble the O-rings and gaskets. When removing parts at locations replace with new parts. When doing this, be careful not to forget to assemble the O-rings and gaskets. When installing the hoses, do not twist or bend them into loops with a small ra dius. This will cause damage to the hos e and drastically reduce its service life.

lean the urface, and CHECK AFTER INSPECTION AND MA INTENANCE WORKS: If y ou forget to perform the checks aft er inspection and maintenance, unexpected p roblems may occur, and this may lead to serious injury or property dam age. Always do the following: e stopped) enance points been forgotten? nance items been performed correctly? Checks after operation (with engin Have any inspection and maint Have all inspection and mainte Have any tools or parts been d inside the machine and get cau Is there any leakage of coolant Have any inspection and maint Have all inspection and mainte Have any tools or parts been d ropped inside the machine?

It is particularl y dangerous i f parts are dropped ght in the lever linkage mechanism. or oil? Have all nuts and bolts been tightened? operating the engine, see "PROPER TOOLS (PAGE 2-33)" and pay careful ance items working properly? oil when the engine speed is raised? Is there any leakage of coolant or oil? Have all nuts and bolts been tightene Checks when operating engine For details of the checks when attention to safety. Are the inspection and mainten Is there any leakage of fuel or For details of the checks when Are the inspection and mainten Is there any leakage of fuel or S (PAGE 2-33)" and pay careful