. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 4 - 26 3. Bl ow dry compressed air 0. 69 MPa (7 kgf/cm2, 99.4 PS I) along fo ou 1 2 3 4 5 6 lds from within element (6 ). Next blow it along folds from the tside, then blow it again from within. ) Remove one seal from the element whenever the element has been cleaned. ent if it has been cleaned 6 times ) Replace the outer elem repeatedly or used thro element at the same ti ughout a year. Replace the inner me. nd outer elements when the air or(1) flashes soon after installing ) Replace both inner a air cleaner clogging monit the cleaned outer elem cleaned 6 times. ) Check inner element m necessary, retighten.
) If seal washer (7) is f nstalling ent even though it has not been ounting nuts for looseness and, if ound damaged or wing nut (5) is ith new ones. valve (8) and clean it with it again after the cleaning. broken, replace them w ) Dismantle evacuator compressed air. Install it again after the cleaning. 4. If small holes or thinner pa rts are found on the eleme nt when it i th s checked by shining a lig ht through it after cleaning, replace e element. NOTIC When cleaning the element, do not Do not use an element whose folds or gasket or seal are damage Wrap u nused element and store th 5. R emove the cloth or tape c over fitted in Step 1. 6.
In stall cleaned element (6) and fix it with wing nut (5).