eng — CHECK AND ADJUSTMENT OF JAW CRUSHER

. MAINTENANCE SERVICE PROCEDURE CAUTION CAUTION to 4 - 40 The outlet clearance is set at 55 mm (2.2 in) (O.S.S.) when the m achine is s hipped out fro m the factory. Ad just it to a desired clearance A set of sh kept in the according to debris to be c rushed. im plates, e.g. 7 plates of 1 2t and one plate of 9t , are in serted on each side. (Shi m plates other tha n those above are tool box) ns the widest clearance at the jaw crusher outlet. O.S.S.mea ns the widest clearance at the jaw crusher outl 1. Start th 2. Set ope ration mode selector sw position 3. Attach a warning tag to the engi ne starting switch t to those going o 4.

Check standin looking (Should crush a into the crusher chambe small stones or debris b e left in the crush nd discharge them, mak ing the chamber e mpty) 5. Depres s jaw crusher inching s witch (3) in the u pper c box, an flywhee d match both red painte lywhe l cover through an inchi 6. Depres s outlet clearance redu box, and push the togg control that the shim plates can be pull 7. Change the overall thickness to a desired outlet c learance adjustin g the number of shim pl Adjust the nu mber of shim plates so tha t they have the sam e thickness on bo 8. Depres s outlet clearance expan sion switch (5), a nd pul the togg 9. Measur e the crusher outlet clea REMARK When takin settin any of O.S.

S. 55 mm (2.2 in), 100 m m (3.9 in), 150 mm (5.9 i 200 mm (7. 9 in), use the outlet clear ance measureme nt gauges the accesso ry parts. An effective m easurement can b (The measu rement gauges are stor ed inside the right wheel as illustrate