eng — CHECK AND ADJUSTMENT OF JAW CRUSHER

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE CONFIRMATION OF LOCKING FORCE AFTER STARTING WORK CAUTION Checking method 4 - 41 10. Store shi m plates, which are n ot used, inside the wheel covers ides as illustrated in the figure at right. adjustment of the out let clearance has been finished. hine is now ready for After adjusti ng the clearance at the outlet of the crushe r jaw, be sure to carry out a trial operatio n under the trial cond itions of engine revo toggle block lution at low idling and crusher revolution at MIN and confirm t hat there is no abn ormal noise from aro und the .

When insert ing shim plates, confir m the total number and thickness o f the right and left shim s to ensure the identi cal shim plate thickn Should the s body. ess on both sides. him plate thickness diff er between the right and the left side s, there would be a critic al damage to the crus her main For some tim e after an operation reduced on accou is started with loa nt of insufficient d, the locking force may be contact of the ims.

e outlet of the the shims or fine foreign objects caug ht between the sh When adjust ment was made of th e clearance at th the crusher due t o the wear on the swi ng jaw plate and f ixed jaw plate, tighten the sh im plates (toggle bloc k) every 30 minut es of operation until no backl ash is confirmed. Hit the shim p lates and the toggle block pins with a h ammer to see if there is any backlash. REMARK If the backlas h can be settled by n o means, remove all the shims once by pushing the t oggle block to the e xtreme front end, foll owing the same proc edure for the jaw crusher outlet clearance adjustmen t, and then blow th em with an air or wate r gun to remove fore ign objects.