. MAINTENANCE SERVICE PROCEDURE CHECK OF WEAR ON MAJOR WEARING PARTS JAW PLATE CAUTION Hatched area : Area of virtual wear CHEEK PLATE If the residual dimension reaches approx. 15 mm (0.6 in) [wear amount 15 mm (0.6 in)] on the upper end and approx. 10 mm (0.4 in) [wear amount 20 mm (0.8 in)] on the lower end, proceed with the replacement. in) 4 - 42 If the m achine is used continuous ly with the crusher chamber ex cessively charged, premature parti al wear will develop on the tips of j aw plates. k is continued with the p artially worn jaw plates, rocks may not be discharged smoothly, eventually resulting in ount of the worsened partial wear. tes with new ones.
r wear limit, a serious damage will be inflicted on the jaw crusher main body itself. If a wor plat rock damage Replace s on the jaw plates on acc ount of the worsened partial w the partially worn jaw pla tes with new ones If jaw pl ates are used beyond thei r wear limit, a serious damage will be inflicted on the jaw crusher If the bott om tips of fixed and swi ng jaw plates have been wo rn off and reach ed the wear limit as illu strated in the figure at right, either reverse o r replace them, as the PROTECT OR residual dimension reaches approx. 10 mm (0 When the [wear am ount 12 mm (0.5 in)], p roceed with the r eplacemen If a partia l wear develops on the protector, replace it , too.