eng — CHECK AND ADJUSTMENT OF JAW CRUSHER

. MAINTENANCE SERVICE PROCEDURE TOGGLE PLATE NOTICE REMARK 4 - 44 If th e wear dim pprox. side, proceed w ith the replaceme Replace a toggl e seat that has be en partially wo rn, as illustrate d in the figure at righ As a n expedient m easuring method, a wear amount on the toggl e seat may be o btained by me asuring the dimens ion between the toggle block and the swin g jaw as insta If th e above dime nsion reaches appr ox. 592 mm (23 togg le seat and to ggle plate, and mea sure their actua l dimensions U se the abov e dimension as a guideline for t he wear tolerance f the toggle seat and toggle p When replac over, too.

ven if any E and oggle plate, there should be n o adverse effe ct on the machine, s far as the noise is generate d by the toggle plate rolling on the oggle seat s urface. If, on the other hand, it is a slapping noise, heck if the t ension spring set length is as s pecified.