. MAINTENANCE SERVICE PROCEDURE REVERSAL OR REPLACEMENT OF FIXED JAW PLATE CAUTION 4 - 46 After dismantling the fixed jaw plate, completely remove soils, sa nd, etc. from the fixed jaw fitting surfac es (front frame and mount stopper upper surface). Unles s removed completely, they may c ause a backlash on the fixed jaw plate . If the clearance is not even on the right and left sides, there will be a slippage from the swing jaw plate tip, which likely leads to premature wear or partial wear on the jaw plates. 1. Dismantle the cheek p lates, referring to the section dealing placement. dealing with the cheek plate re 2. Remove the fixed jaw plate wedge bolts and fixed ja w wedge lock.
Tools to use ccessory Tool No. 9 cessory Tool no. 11 essory Tool No. 12 te with a wire rope. fixed jaw plate, lower it on to a block (1) Extension socket: A (2) Ratchet handle: Ac (3) Extension pipe: acc 3. Lift up the fixed jaw pla When reversing the once. Then hook a w insert it into the crus When replacing the block once. Then lift and insert it into the When reversing the ire rope on the other side to lift it up and her frame. worn fixed jaw plate, lower it on to a When replacing the up a new fixed jaw plate with a w ire rope crusher frame. 4. Take measurements o f the clearance on both sides of fixed the fixed jaw plate and the crusher ers are aligned.
of fixed jaw plate, and position crusher frame so that both cent 5. Insert a sleeper, e.g. ti e (or equivalent) between the f ixed jaw plate and swing jaw pla te. 6. Push out the swing jaw plate with a hydraulic ram to p ress the fixed jaw plate against the front frame. For this work, refer to the section dealing w clearance. ith adjustment of the crusher outlet