. MAINTENANCE SERVICE PROCEDURE REVERSAL OR REPLACEMENT OF SWING JAW PLATE 1. Remove rubber plate (1) fitted to swing jaw cover (A). CAUTION REMARK Applicable shacle Nominal size (a): 16 mm (5/8 inch) Length (b): More than 32 mm (D type, wide D type) 3. Loosen the mesh by hitting (4) swing jaw plate wedge with sledge-hammer. jaw plate wedge using hammer.) side likewise, and hold it with wood ship. 4 - 48 When pushing out the swing j aw plate wedge from behind the swing jaw, keep the two fixed jaw p late wedge center bolts as inserted to prevent the swing j aw plate wedge from falling off. 2. Loosen four fixed jaw pl ate wedge bolts (2) and remove the two at outside.
Keep the tw off fixed jaw plate wedg Tools to use (1) Extension socket: A (2) Ratchet handle: Acc (3) Extension piping: Ac (4) 2 shackles: Accesso (5) Swing jaw stopper: (6) 2 wood chips: Acces (45 x 45 x 250 mm) (7) 2 bars (8) Sledge-hammer o center bolts as inserted, after taking e sprngs (3) and fitting the nuts. ccessory Tool No.10 essory Tool No.11 cessory Tool No.12 ry Tool No.17 Accessory Tool No.20 oory Tool No.26 swing jaw stopper (tool No.20) in the jaw back side, and push out (4) swing 4. Hold up the swing jaw old it with wood chip. Hold up another 5. Connect the wire rope t o 2 bolt holes of outer side with shacle.