. MAINTENANCE SERVICE PROCEDURE CHECK AND ADJUSTMENT OF JAW CRUSHER V-BELT the tension of 85.0N(8.7kgf), of the V belts, CRUSHER AND ADJUSTMENT CAUTION meter and adjust the tension to obtain an average value of 4 - 65 CHECKING 1. Open the V be each V belt wit For the measur inspection of ja 1. 1. each V belt wit h a tension meter. For the measur ement method , refer to the sec inspection of ja 2.
Calculate the a verage of the measur ed tension the average t ension value obtain ed lowers tighten the V b elts in the following p rocedures For the details on inspection and a djustment refer to the c hapter, "CHECK O F JAW C RELATED AC CESSORIES ( PAGE 3-44)" in V belts have a charac teristic that their tensio n tends to l ower by 20-30% in 24 hours after the engine st belt tension every 24 operating hours and ev ery 250 op erating hours without fail. If the tension of any lower limit, tighten it. 1. Loosen the tur nbuckle lock nut. 2. Turn the turnbu ckle with a monkey wrench to 3. Measure each 109N(11.1kgf). * With new V b elts, adjust them to o btain an a 4.
Tighten the tur nbuckle lock nut.