eng — CHANGE OIL IN HYDRAULIC TANK AND CLEAN STRAINER

. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN HYDRAULIC TANK AND CLEAN STRAINER WARNING may cause burns. Wait for the 4 - 82 EVERY 5000 HOURS SE Carry out the periodic mainten ance work of every 100, 250, 500 and 1000 hours of operation a t the same tim temperature to go down before When removing the oil filler ca p, turn it slowly to release the internal pressure, t hen remove opped, and A container of capacity ove r 270 liters (71.33 US gal) to r eceive drained oil Replacement amount of oil Prepare a handle (for the s 1. Remove the cap of oil fille tank. 2. Set a container direct un machine's underside to ca plug (P) and drain the oil.

C and if it has a scratch or da draining the oil, tighten dra The specified tightenin ·m, 50.6 ± 7.2 lbft) Take care not to get oil plug (P). 3. Add the specified amount the oil level is between H For an oil level checking m (PAGE 3-39)". 1. Remove the cap of oil fille tank. Set a container direct un 2. machine's underside to ca tch oil that is drained. Remove drain plug (P) and drain the oil. C heck an O-ring installed to Plu g (P), and if it has a scratch or da mage, replace it with new one. After draining the oil, tighten dra The specified tightenin g torque is 68.6 ± 9.81 N·m (7 ± 1 kgf 3.

Add the specified amount of new and clean engine oil (for hydrauli c system) through oi l filler p ort ( F). Check that the oil level is between H and L on the sight gauge. For an oil level checking m ethod, refer to the section of " CHECK OIL L EVEL IN HYDRAULI C TANK, ADD OIL (PAGE 3-39)". Take care not to get oil on yourself when you remove drain AIR BLEEDING PROCEDURE Bleed air from the hydraulic ta nk following the procedures e xplained below