eng — CHANGE OIL IN HYDRAULIC TANK AND CLEAN STRAINER

. MAINTENANCE SERVICE PROCEDURE BLEEDING AIR FROM MAIN PUMP the air bleeder. 2) If no oil oozes out, remove the drain hose from the pump case, and add hydraulic oil through drain port (2) to fill the pump case. Oil will come out when the drain hose is removed, so secure the hose mouthpiece at a position higher than the level of the oil in the hydraulic tank. 4 - 83 For details, see "STARTING EN GINE (PAGE 3-49)". If it is necessary to refer to the items f or starting the engine, moving the machine off, steerin g, or stopping, see the OPERATION 1.

Bleeding air from pump 1) Loosen air bleed plug (1) and check that oil oozes out from 3) After completing the air bleed operation, tighten air bleed plug (1) and install the dra NOTICE will spurt out from plug hole (1). If the drain hose is installed first, oil If the pump is operated without fillin g the pump case with hydraulic oil, a bnormal heat will be generate d and this may cause an unexpected damage to the pump. STARTING ENGINE Star t the engine, referring to the section of "STARTING ENGINE ( PAGE 3-49)". Hold the eng ine speed at low idling (MIN ) for the initial ten minutes and then proceed to the next work.

BLEEDING AIR FROM CRUSHER MO TOR , then loosen drain hose (1) an drain hose (1). 1. 2. I 3. 4. I 1. Run the engine at low idling check that oil seeps out from 2. I f oil does not seep out, stop the engine and disconnect drai hose (1), and fill the crusher motor case with hydraulic oil. , connect drain hose (1). to keep slow revolution. 3. After completing air bleeding 4. I dle the engine at low speed