eng — CHANGE OIL IN HYDRAULIC TANK AND CLEAN STRAINER

. MAINTENANCE SERVICE PROCEDURE BLEEDING AIR FROM GRIZZLY FEEDER MOTOR 4 - 84 1. Run the engine at low id ling, then loose check th at oil seeps out f rom drain hose (1). 2. If oil doe s not seep out, st op the engine, t hen d isconne ct drain hose (1) and fill the moto r case with hydraulic 3. After co mpleting air blee ding, connect dr ain ho se (1). 4. Idle the engine at low sp eed to keep slow BLEEDING AIR FROM CONVEYO NOTICE For r eplacing oil in the conveyor motor machinery case, p repare a suitable scaffold for s afety and commenc e the work. machinery case: 3.0 m (9 ft 10 in)] [AGL height o f conveyor motor machinery case: 3 .0 m (9 ft 10 in) 1.

Idle the engine at low sp eed and loosen drain hose ( 1) at the connect ing port. Then ch eck that oil seep s out f rom dr ain hose (1). 2. If oil doe s not seeps out, stop the engine , then disconnect the connect ydraulic oil. 3. After co mpleting air blee ding, connect dr ain ho se (1). 4. Idle the engine at low sp eed to keep slow