. OPERATION EXPLANATION OF COMPONENTS of the "Travel", REMARK When the mode selector switch is at the "Travel" position, the work equipment (jaw crusher, belt conveyor, grizzly feeder and any other options) may not be set in motion, even if their respective starting switches are depressed. LAMP SWITCH This switch (3) turns on the head lamps and the panel lamps. OFF Position: The lamps are switched off at this position. Position 1: The panel lamps are switched on. Position 2: The head lamps and the working lamps are switched on.
3 - 18 MODE SELECTOR SWITCH This switch (2) allows an operator to "Work" and "Inspection " modes select any The r elationship between each mode and the possible motions of the w ork equipment is shown i n the table below. No.
Device (Motion) Mode Remark Work Travel Inspection (1) Crusher continuous operation Q ° ° (2) Crusher inching operation Q ° Q (3) Grizzly feeder operation Q ° ° (4) Primary conveyor operation Q ° ° (5) Magnetic separator operation (if equipped) Q ° ° (6) Debris discharging conveyor (if equipped) Q ° ° (7) Crusher outlet clearance adjustment ° ° Q (8) Primary conveyor raising/lowering Q Q Q (9) Debris discharging conveyor raising/lowering (if equipped) Q Q Q (10) Foldable type hopper cylinder (if equipped) Q Q Q (11) Travel ° Q ° Machine does not travel when primary conveyor is lowered (working posture).