eng — SWITCHES

. OPERATION EXPLANATION OF COMPONENTS Guideline for dial adjustment SOFT HARD Concrete debris Andesite Granite Limestone Sandstone Basalt Graywacke (Hard sandstone) TRAVEL SPEED SELECTOR SWITCH WARNING 3 - 23 CRUSHER CHARGE SETTING DIAL This dial (17) serves to constantly m aintain the chargi ng rate at the crusher c hamber at a ts capacity under any working condition capability This dial grizzly fe eder to the c Keep wa tching the cr usher chargin starting c rushing work , and adjust the crusher charge setting dia o the op timum level. f you try t o change the t ravel speed fro m the Hi to Lo positi on, while the machine is traveling, the machine may s werve fr om the straight p ath.

e travel speed after stopping machine once. Change th e travel speed after stopping machine This swit ch (18) is use d to change t he travel speed in two stages Position (a): Travel in high speed low speed Position (b): Travel in REMARK When the t travels machine is r at a low spe un by means ed without a of the optional rad ny relation to the io controller mode of the ravel sp eed selector switch. BUZZER STOP SWITC NOTICE f the engi ne starting swi tch is turned OF F because some ab normality has been noticed in the m achin e, and turne d ON again, the buzzer so unds, unless t hat abnormality has not been remov ed.

This swit ch (19) stops the buzzer fr om ringing, when it bigins to ri ng to warn against any o f the warn ing items t hat has occu rred while th e engine is ru nning.