eng — CHECK BEFORE STARTING ENGINE

. OPERATION OPERATION CHECK OF PRIMARY CONVEYOR WARNING 3 - 43 Whe n correcting zigzag movement of th e primary convey or, carry th at out 1. Forei gn materials such as ston es, gravel, wire chips, iron and steel bar chips, etc. are likely caught in various parts of the primar y conveyor. C heck for them i nside the conveyor, between the roller s and the belt, inside the hoppe r rubber and the belt as well as inside th e return ro ller g uides. If found, remove 2.

Zigza g movement of conveyor If run the an In on the bra ad If the c onvey or belt show while ning, correc t it by turning the adjusting bol ts provide d on right d (b) case and lef at right the ad t sides of the belt, as shown in the figures (a) . justment cannot be perfected by adjusting ly the adjusti ng bolts at the tail pulley, try to correct it with bolts securi ng the carrier roller bracket a nd return r oller cket, 3. Chec k that there i s no damage nor cut on the b elt rubber CHECK OF GRIZZLY FEEDER NOTICE NOTICE Park the m achine on the level and solid ground, then carr y out this c heck. 1. Chec k the drive m otor for oil lea 2. Chec k the grizzly bars for clogg 3.

Chec k that the oil level in the vi brator case is in the middl e of