STEERING COLUMN-MOUNTED CONTROLS To signal a left turn, pull the lever back (counterclockwise). To return to previous beam: pull the lever towards the steering wheel again. After you complete a turn, shut the system off by returning the lever to the "OFF" (center) position. Failure to shut off a turn signal could con- fuse other drivers and result in an injury accident. An indicator light in the instrument panel will flash until the turn signal is turned off. WARNING! Each time the turn indicator is activated the audible warning emits a short beep. The high beams can be momentarily flashed with or without the headlights being on.
To flash the high beams, gently push the headlight lever away from the steering wheel to momentarily turn on the lights. NOTE If the vehicle turn signals and turn signal indicators in the dash gauge cluster ever begin flashing at an accelerated rate (115 cycles per minute) when the turn signal lever is in the OFF (center) position, or when a Right/Left turn has been se- lected, the problem may be related to a failed turn signal switch or turn signal module. In either case, the problem is not a failed bulb. Contact your nearest authorized dealer to have the problem corrected as soon as possible. 3 High Beam NOTE NOTE Continued pressing of the high beam flash will not keep the high beams on.
The headlights must be ON for the high beam switch to operate. To switch your headlights to lower or higher beam, gently pull the turn signal lever, toward the steering wheel, until you hear the switch click and the beam changes. The blue indicator light in the instrument panel will be ON when the high beam is being used. (03/17) Y53-6060-1C1 3-43