Peterbilt Medium Duty — Engine Block Heater (Option)

STARTING & OPERATING manual for the right pressure for your engine. If the oil pressure doesn’t rise within a few seconds, stop the engine. Find out what is wrong before restarting the engine. Cold Weather Engine Block Heater (Option) In cold weather, fast engine starting helps relieve the loads on the electrical system and cranking motor. Using the special cold starting equipment will help starting. If you follow a few simple guidelines, you will extend the service life of your engine. To preheat the engine before starting, plug the optional engine block heater into a properly grounded AC electrical source. Do not start the engine with the heater plugged in. 7.

Slowly engage (release) the clutch after the engine has started. 8. Wait for the oil pressure gauge to reach normal operating pressure before operating the vehicle or idling faster than 1000 rpm. Keep the electrical system in top condition. WARNING! Engine block heaters can cause fires which may result in death, in- jury and/or property damage if not properly maintained and operated. Regularly inspect the engine block heater wiring and connector for damaged or frayed wires. Do not use the heater if there are any signs of problems. Contact your autho- rized dealer or the manufacturer of the heater if you are in need of re- pairs or information.

4 Use the best quality fuel of the recommended grade. Use recommended engine lubricating oil. Fully depress the accelerator pedal after engaging the starter. For manual transmissions and auxiliary transmissions, leave the transmission in neutral and allow the transmission lubricating oil to warm up (approximately 3-5 minutes) before operating vehicle. 4-6 Y53-6060-1C1 (03/17)