Peterbilt Medium Duty — Engine Warm-up

STARTING & OPERATING Engine Warm-up Engine slowly and evenly. In extremely cold temperatures, you may have to increase idle speed. Always unplug heater before starting the engine. Damage to the cooling system could occur if the heater is not turned OFF (unplugged). CAUTION The purpose of engine warm-up is to allow oil film to be established between pistons and liners, shafts and bearings while your engine gradually reaches operating temperature. NOTE In colder climates where the tem- perature is often below freezing, the warm-up for turbocharged en- gines is especially important.

Chilled external oil lines leading to the tur- bocharger will slow the oil flow until the oil warms, reducing oil available for the bearings. Watch the engine oil temperature or pressure gauge for a warming trend before increas- ing engine idle speed (RPM). Depending on engine make, when the temperature falls below -10° F (-24° C), the block heater is required. Warm-up Procedure Use a solution of half ethylene glycol antifreeze and half water for best heater performance. Do not exceed 65 percent concentration of antifreeze, as a shortened heater life will result. See Engine Cooling System on page 5-80, for more information. 1.

After you’ve started your engine, idle it at approximately 600 RPM while you check: 4 a. oil pressure b. air pressure c. alternator output 3. Continue the engine warm-up until the coolant temperature reaches at least 130° F (54° C). At this temperature, you can use partial throttle. Wait until the coolant temperature is at least 160° F (71° C) before operating at full throttle. After servicing the cooling system, operate the vehicle for a day or two before using the heater. Trapped air inside the engine needs time to escape. 2. After a few minutes of idling at 600 RPM, increase your idle speed to 900 or 1000 RPM. Continue your warm-up.

This procedure allows oil to warm and flow freely while pistons, liners, shafts, and bearings expand (03/17) Y53-6060-1C1 4-7