Peterbilt Medium Duty — Putting the Vehicle in Motion

OPERATING THE TRANSMISSION Putting the Vehicle in Motion start up on an incline, apply your service brakes before you release the parking brake. Then release your service brakes as you engage the clutch and apply throttle. After making sure the vehicle's oil and air pressure are correct and all other parts and systems are in proper working condition: Always use first gear or a low speed range to start the vehicle in motion. The use of a higher gear or speed range forces undue strain on the en- gine, clutch, other transmission com- ponents, and may cause damage.

CAUTION For further instructions on operating your transmission, see the transmission manufacturer's Driver/Operator's Instruction Manual. 1. Fully depress the clutch pedal (for manual transmission) until the clutch brake makes contact. 2. Evaluate the road surface conditions and terrain your vehicle is on. Select a gear low enough to let your vehicle start forward with the throttle at idle. a. The total stroke of the clutch pedal is about 6 inches (152 mm). The first Ѕ inch (13 mm) is free travel. After the free travel comes the release stroke, which is the part that fully releases the clutch. The last Ѕ inch (13 mm) engages the clutch brake.

If you have a misaligned gear condition in your vehicle's transmission and cannot start, gradually release the clutch, allowing the drive gear teeth to line up properly. Then the drive gear can roll enough to allow the teeth to line up properly and complete the shift. 4 3. Push the parking brake valve handle (Yellow) against the dash panel to release the brakes. b. Always start out in a low gear. Starting in higher gears, even with a light load, will cause a very jumpy start and excessive wear. 4. Release the clutch pedal (manual only), then gradually accelerate to permit smooth starting, The best engine performance and maximum economy is obtained if gears are properly selected.

This efficiency is achieved by always selecting gears within optimum engine RPM, which is where maximum torque and power are obtained. For further information, see 5. Do not allow your vehicle to roll (even a little) in the opposite direction during clutch engagement. If you need to (03/17) Y53-6060-1C1 4-19