Peterbilt Medium Duty — Parking Brake

OPERATING THE BRAKE SYSTEM Parking Brake Parking brakes work in reverse action of the regular brakes. When the parking brakes are engaged, air is exhausted from the spring chambers which allow the spring to engage the brakes. This design also provides for the safety function if a brake circuit has a leak and loses air. In such a scenario, the parking brakes will apply. brakes but will not disengage the trailer parking brakes (if applicable). Either knob will pop back out if the system pressure is not above 60 psi (414 kPa). The instrument panel display will provide a message any time the parking brakes (vehicle or the trailer) are set and the vehicle is put into motion.

The vehicle’s parking brake controls are the yellow diamond shaped knob on your dash board. If the vehicle is equipped to tow a trailer, then there will be an additional red octagon shaped knob for the trailer parking brakes. Parking brakes will be engaged when either of these knobs are pulled OUT. (If one knob is pulled out, the other knob will automatically pop out.) 4 1. Normal Run Position 2. Trailer Park With Vehicle Released 3. System Park or Trailer Charge With Vehicle Parked Pushing IN a knob will disengage the respective parking brakes. If you push in the yellow knob only, you will disengage the vehicle’s parking (03/17) Y53-6060-1C1 4-43