Peterbilt Medium Duty — Cruise Control Switch

CRUISE CONTROL CRUISE CONTROL (48 km/h) for the Cummins and PACCAR PX series engines) and the engine speed is above 1100 rpm. Cruise Control Switch Changing the Cruise Set Speed This vehicle may have cruise control switches located on the steering wheel instead of the switches on the dash board. The instructions are still the same. For vehicles with cruise control buttons on the steering wheel, the cruise speed may be changed by using the +/- button. The pressing and holding the + button will increase speed while pressing and holding the - button will decrease speed. For vehicles with dash mounted cruise control switches, changing the speed is done through the "Set/Resume" button.

To increase the speed, press and hold the Set button. To decrease the speed, press and hold the "Resume" button. 2. Press the "ON/OFF" button. 3. Accelerate the vehicle to the desired cruise speed. 4. Press the "SET" button to set the cruise speed. To Turn On: 4 Press the ON/OFF button. Cruise Control may not hold the set speed going down hills. If the speed increases going down a hill, use the brakes to slow down. This will can- cel Cruise Control. NOTE To Turn Off: Press the ON/OFF button. Any previous speed settings are cleared. Using Cruise Control While Driving Cancelling Cruise Control Setting Cruise Speed You can cancel cruise control in any of these ways: 1.

Ensure that the vehicle speed is above the minimum cruise control speed (19 mph (30 km/h) for PACCAR MX engine and 30 mph Tap the brake pedal. Tap the clutch pedal. 4-44 Y53-6060-1C1 (03/17)