Peterbilt Medium Duty — Auxiliary Axles - Pusher or Tag

AXLE General Calibration Guidelines 4. Adjust the amount of load on each axle by turning the pressure regulator clockwise to increase the load or counterclockwise to decrease the load. (The suspension manufacturer may publish pre-established Pressure-to-Load Ratio Pressure Settings to assist you in achieving an estimated ground load). Operation guidelines These instructions are general in nature. For more specific instructions, review the pusher or tag suspension manufacturers maintenance manual or contact the nearest authorized dealer. NOTE Steerable-pusher and/or tag axle(s) will raise when the transmission is shifted into reverse or when the parking brakes are applied.

Perform this procedure at or near a weight scale. Procedure can be per- formed while parked on the weight scale if scale is available. NOTE 5. After setting the pressure to obtain the desired axle load, verify proper ground loading with the weight scale. 4 1. Park loaded vehicle on level surface with wheels blocked. NOTE 2. Release vehicles spring brakes. (Do not release for Liftable/Non-Steerable pusher or tag axles). Exceeding local, state or federal weight limits may result in cita- tions. Contact your local commercial weight enforcement office for limits in your area. 3. Lower the pusher/tag axles with the axle lift control flip valve.

(For some non-liftable axles, inflate air suspension). 4-54 Y53-6060-1C1 (03/17)