Peterbilt Medium Duty — Auxiliary Axles - Pusher or Tag

AXLE Liftable/Steerable or Liftable/Non-Steerable Pusher and/or Tag Axle Calibration Procedure Setting the Pressure-to-Load Ratio A change in tire size on either the auxiliary axles or the drive/steer axles can change the calibration of the auxiliary axles. If tires are installed with a different loaded ra- dius, the calibration procedure must be repeated. Failure to do so can cause equipment damage. CAUTION To obtain the desired axle load distribution, you must correlate the suspension air gauge pressure to the actual axle load by scaling the axle weight(s) and adjusting the pressure to obtain the desired load.

Once the desired load or load range is achieved, document the pressure-to-load ratio or setting for future use. Below are some general instructions on how to adjust and calibrate the air control valve for the auxiliary axles to obtain the proper load distribution of the axle(s). For additional operating and maintenance instructions, see the pusher or tag suspension manufacturer literature in the glove box or contact them directly. 4 This procedure must be performed prior to placing the vehicle into ser- vice. NOTE (03/17) Y53-6060-1C1 4-53