SUSPENSION SUSPENSION Setting Ride Height Vehicles equipped with rear air suspensions have their ride height and axle (pinion) angle(s) preset at the factory. These are precision settings and should not be altered. Incorrectly adjusted ride height may result in improper interaxle U-joint working angles. This can result in premature driveline wear and driveline vibration. If your vehicle is equipped with a Peterbilt rear air suspension, and if it becomes necessary to reset the ride height, you may temporarily set it by following the next procedure. Proper ride height measurement and values for a fully laden vehicle are shown in the illustration and table below.
Ride Height Measurement (Location for Tandem Axles Shown) 4 Follow this procedure to temporarily set ride height.
(03/17) Y53-6060-1C1 4-57 Unladen Vehicle Propri- etary Rear Ride Height, inches (mm) Air Sus- pension Single Drive Tandem Drive Air Leaf N/A 12.0 (305) Air Trac 11.38 (289) 11.38 (289) Low Air Leaf (Before April 2004) 8.75 (222) 8.75 (222) Low Air Leaf (After April 2004) 6.75 (171) 8.75 (222) Low Low Air Leaf N/A 6.75 (171) FLEX Air N/A 8.75 (222) Fully Laden Vehicle Propri- etary Rear Ride Height, inches (mm) Air Sus- pension Single Drive Tandem Drive Air Leaf N/A 11.70 (297) Air Trac 11.00 (279) 11.00 (279) Low Air Leaf 6.50 (165) 8.50 (216) Low Low Air Leaf N/A 6.50 (165) FLEX Air N/A 8.50 (216)