SUSPENSION WARNING! 2. Ensure the air supply and delivery plumbing of the height control valve is consistent with the following illustrations. Ensure that a vehicle is parked and the wheels chocked before begin- ning this procedure. CAUTION Completing this procedure will en- able you to safely reach the nearest authorized Peterbilt repair facility to have ride height and pinion angle re- set using the proper equipment and technique. Do this as soon as possi- ble to avoid potential driveline dam- age. Typical Height Control Valve (Rear View Looking Forward) 4 1.
Alignment Dowel NOTE Typical Height Control Valve (Location on Vehicle) At least one of the mounting holes in the height control valve bracket will be slotted to permit rotating the valve. NOTE Suitable wheel chocks are at a min- imum an 18-inch (46 cm) long 4x4. On dual-valve systems, begin with the LH valve on the next step. 1. Ensure that the tractor is fully laden during this procedure. Do not use these procedures on a vehicle that is not laden (bobtail). 3. Loosen the fasteners mounting a height control valve to its bracket. 4-58 Y53-6060-1C1 (03/17)