SUSPENSION WARNING! 6. Torque the mounting fasteners to 55-75 Lb. in. (6.2-8.5 Nm.). The rear of a vehicle will drop about 3 1/2 inches (88 mm) when the air springs are deflated. Ensure that no persons or objects that could be killed, injured or damaged are under the vehicle before deflating the air springs. 4. Rotate the valve either clockwise or counterclockwise until air pressure in the air springs provides the ride height specified for that suspension. Measure the ride height from the bottom of the frame rail to the approximate centerline of the rearmost drive axle hub: 7. Remove the alignment pin or dowel. 8.
Repeat Steps 2 through 6 above for the RH valve on vehicles with a dual-valve system. For tandem axles, make the vertical measurement at the centerline of the suspension (see illustration on page 4-58). To minimize risk of death, personal injury or property damage, do not use a dump valve to deflate the air springs. Rotate the height control valve(s) manually to ensure positive control of air spring deflation. 4 For a single axle, make the measurement in front of the axle, in the area forward of the tires but not past the suspension bracket. 5.
When at the correct ride height, ensure that the height control valve lever is in the neutral position, then install either the built-in alignment pin or a 1/8-inch (3 mm) dowel (see illustration on page 4-58). To minimize risk of death or personal injury, keep away from air springs as they are being inflated. (03/17) Y53-6060-1C1 4-59