BRAKE SYSTEM 3. Insert the rubber diaphragms into the reservoirs. Make sure that the fluid level registers on or above the fluid level mark molded on the reservoir - add more if necessary, as follows: 4. To prevent leakage from the reservoirs, ensure that the seal in each reservoir cap is in good condition before refitting the cap. 1. Remove each reservoir cap and extract the rubber diaphragm from each reservoir. If the brake fluid reservoir requires an excessive amount of hydraulic fluid, the complete system must be inspected for leaks and repaired if necessary (consult your nearest Pe- terbilt dealer).
Failure to keep the brake system in good repair may lead to loss of braking and possibly cause serious personal injury. WARNING! System Components CAUTION When replacing disc brake pads, be sure to use the same lining material on both axles. Mixing lining types can result in unbalanced braking, increased pad wear, or degraded stopping performance. Consult your nearest Peterbilt dealer. 5 Booster and Master Cylinder Assembly Service Brake Component Inspection 2. Fill each reservoir with clean hydraulic fluid of the approved specification (DOT 3 brake fluid). Remove each wheel to inspect the brake components. Disc brake pads - Visually inspect all brake pad linings.
Brake pads should be replaced when the remaining lining reaches 3⁄16 inch thickness or (03/17) Y53-6060-1C1 5-69