Peterbilt Medium Duty — Brake Adjustment

BRAKE SYSTEM less. It is recommended that all disc brake pads be replaced at the same time since this will maintain balanced braking. At a minimum, replace all disc brake pads on one axle, both ends, at the same time. pin boots or other defects. If signs of wear, damage or defects are found, the anchor plate(s) should be repaired or replaced. Parking Brake Component Inspection Calipers - Visually inspect calipers for brake fluid leakage, damaged or defective pistons or piston boots. If there is evidence of leakage, damage, or other defects the caliper should be replaced or repaired.

If you are not properly trained to per- form brake inspections or service, take your vehicle to your nearest Pe- terbilt dealer. NOTE Disc brake rotors - Visually inspect rotors for scoring, warping, cracks, bluing or heat spots or other damage or defects. If signs of damage or defects are found, the rotor(s) should be resurfaced or replaced in accordance with the vehicle manufacturer's recommended service procedure. Visually inspect brake shoe lining for wear, cracks, or breakage. If linings are worn down to 2.5 mm (0.10 in), they must be replaced. Inspect brake drum for deep scores, heat spots, cracks, or damage. Replace if needed.

5 Anchor plates - Visually inspect anchor plates for worn or damaged slippers, damaged or dislodged guide 5-70 Y53-6060-1C1 (03/17)