Peterbilt Medium Duty — Safety Restraint System - Inspection

CAB vehicle requires thorough inspection every 20,000 miles (32,000 km). If the vehicle is exposed to severe environmental or working conditions, more frequent inspections may be necessary. WARNING! Factors contributing to reduced seat belt life: It is important to remember that any time a vehicle is involved in an ac- cident, the entire seat belt system must be replaced. Unexposed dam- age caused by the stress of an acci- dent could prevent the system from functioning properly the next time it is needed. Failure to comply may re- sult in death or personal injury. Heavy trucks typically accumulate twice as many miles as the average passenger car in a given time period.

Any seat belt system that shows cuts, fraying, extreme or unusual wear, significant discoloration due to UV (ultraviolet) exposure, abrasion to the seat belt webbing, or damage to the buckle, latch plate, retractor hardware or any other obvious problem should be replaced immediately, regardless of mileage. Seat and cab movement in trucks causes almost constant movement of the belt due to ride characteristics and seat design. The constant movement of the belt inside the restraint hardware and the potential for the belt to come in contact with the cab and other vehicle parts, contributes to the wear of the entire system.

5 Environmental conditions, such as dirt and ultraviolet rays from the sun, will reduce the life of the seat belt system. Due to these factors, the three-point safety belt system installed in your 5-76 Y53-6060-1C1 (03/17)