NOISE AND EMISSION CONTROL Exhaust Tail Pipe Engine Fan and Shroud Hood Insulation Blanket Check the mounting. Tighten as necessary. The miter cut at the tip of the pipe must be facing the rear of the vehicle. Do not modify the end of the pipe in any way. WARNING! Check all fasteners for condition and security. Repair or replace any broken or defective fasteners. Do not work on the fan with the en- gine running. The engine fan can engage at any time without warning. Anyone near the fan when it turns on could be injured. Before turning on the ignition, be sure that no one is near the fan. Check for chafing or tears. Patch it if necessary. Find the cause of the damage.
If any component or accessory is causing wear or damage and cannot be relocated, put reinforcing pads on the blanket at the site of wear. Check all fasteners for tightness. Check for stress cracks in the shroud. Make sure the shroud is adjusted so that it does not touch the fan blades. 5 Check to verify that the fan is disengaged (not turning) with the engine running at normal operating temperatures (from cold to the point that the fan engages). Check fan blade mounting bolts. Inspect fan blades to be sure they are not cracked or bent. 5-128 Y53-6060-1C1 (03/17)