Peterbilt Medium Duty — Fuse or Relay Blows

WHAT TO DO IF... off. This allows the engine to cool gradually and uniformly. WARNING! Fuse or Relay Blows 7. If overheating came from severe operating conditions, the temperature should have cooled by this time. If it has not, stop the engine and let it cool before checking to see if the coolant is low. To reduce the chance of death, per- sonal injury and/or vehicle damage from overheated engines, which can result in a fire, never leave the en- gine idling without an alert driver present. If the engine should over- heat, as indicated by the engine coolant temperature light, immedi- ate action is required to correct the condition.

Continued unattended operation of the engine, even for a short time, may result in serious engine damage or a fire. Fuses are located behind the drivers side kick panel, below the ignition switch, and accessible by a door panel. See Fuse Panel on page 5-88. 2 WARNING! Do not replace a fuse with a fuse of a higher rating. Doing so may damage the electrical system and cause a fire. Failure to comply may result in death, personal injury, equipment or property damage. For further information on engine temperature and operating engines properly, see the Engine Operation and Maintenance Manual and Starting & Operating the Vehicle on page 4-5.

Check the coolant level after each trip when the engine has cooled. The coolant level should be visible within the surge tank—add coolant if necessary. See Topping Off in Engine Cooling System on page 5-80, for instructions on checking and filling the coolant expansion tank. CAUTION Do not remove the radiator fill cap while the engine is hot. Scalding steam and fluid under pressure may escape. You could be badly burned. Failure to comply may result in death or personal injury. WARNING! Before replacing a fuse, turn OFF all lights and accessories and remove the ignition key to avoid damaging the electrical system. 2-6 Y53-6060-1C1 (03/17)