Peterbilt Medium Duty — Fuse or Relay Blows

WHAT TO DO IF... Fuse Inspection and Replacement Never patch fuses with tin foil or wire. This may cause serious dam- age elsewhere in the electrical cir- cuit, and it may cause a fire. CAUTION All the electrical circuits have fuses to protect them from a short circuit or overload. If something electrical on your chassis stops working, the first thing you should check for is a blown fuse. If it is blown, replace it with a fuse of the same rating. If a fuse of the same rating is not available, a fuse of a lower rating may be temporarily substituted. You can also use a fuse from a circuit you can do temporarily without (for example an accessory circuit or radio).

2 CAUTION If a circuit keeps blowing fuses, have the electrical system inspected for a short circuit or overload by an au- thorized dealer as soon as possible. Failure to do so could cause seri- ous damage to the electrical system and/or vehicle. 1. Turn OFF all lights and accessories and remove the ignition key to avoid damaging the electrical system. CAUTION 2. Determine from the chart on the fuse panel which fuse controls that component. When replacing a failed circuit breaker, always use an approved circuit breaker with a current rat- ing equal to or less than the circuit breaker being replaced. Only use the approved Type II modified re- set circuit breakers.

NEVER use a Type I (automatic reset) or Type III (manual reset) circuit breaker. A fuse with a current rating equal to or less than the circuit breaker being replaced can also be used. 3. Remove that fuse and see if it is blown. 1 Blown (03/17) Y53-6060-1C1 2-7